16. You configure the network adapter card for each Win2000 Professional
computer to use TCP/IP and assign static IP addressing information. You
configure two computers with 10/100 MBPS UTP-only network adapter cards.
On all other computers, you use 10 MBPS BNC/UTP combination network
adapter cards. All computers are connected to a 10/100 switch that has
category 5 UTP cabling. After the installation you find that only the
computers with the 10/100 MBPS UTP-only cards can communicate with each
other.
What should you do so that all computers on the network can communicate
with each other?

A. Change the combination network adapter cards to use the UTP transceiver
setting.
B. Configure the 10/100 switch to transfer only at 100 MBPS
C. Configure the 10/100 switch to transfer only at 10 MBPS
D. Configure the 10/100 MBPS network adapter cards to switch all the
computers at 10 MBPS
E. Configure all network adapter cards and switches to transfer at 10 MBPS
F. Change the combination network adapter cards to use the BNC transceiver
setting.

It claims the answer is A....but I have seen this question in transcender and according to that, the answer would be D, and I think I would agree with D?

Report this post to a moderator