| exo_wa 2003-03-26, 1:54 pm |
| Hi I need some help on how to set up a VPN on NetScreen 25 using W2Ks as client. I have found a few documents on www.netscreen.com, tried but didn't seem to be working for me. Netscreen support said they don't have specific instruction for W2K/Netscreen25 but folks out there have configured it to work.
Here's my testing environment:
I have 3 Eth Interfaces on Netscreen 25:
E1 (NAT,Trust) is private network. E2
(DMZ,ROUTE)is also private network reserved for
Servers exposing to the Internet. E3 (Untrust,ROUTE)
is interfacing the Internet via a Router.
E1=192.168.20.10 (has two stations so far)
E2=192.168.30.1 (has two stations so far)
E3=66.214.37.37 (using my laptop)
When I tested the VPN configuration, I used the
workstation residing on E3 (supposedly coming from the
outside).
As for Remote Client, I used the Microsoft Built-in
Remote Client BECAUSE my boss doesn't want to use buy
NetScreen Remote Client. It's tough for me now...but
then since I am new to this, i wouldn't know which one
is tougher. It all seems tough to me.
QUESTION:
1)Do you think I have set up a valid testing
environment? If not, how would I do it, otherwise?
2)With regards to PreShared Keys I found under
Proposal 1 and 2, Is that something I just cut and
paste or assign to a user every time i create one?
3)Any suggestions on how I setup Microsof VPN client?
It seems fairly simple but being new, I might have
overlooked something.
I would appreciate any helps or tips at all.
Thanks in advance.
-Exo (exo_wa@yahoo.com) |