CCNP - Aironet 1200 series problem

Author

Aironet 1200 series problem

haseeb_eng

2002-08-25, 3:25 am

On my laptop i had installed 802.11b PC card (AIR-PCM352) to make wireless network with aironet 1200 . On my laptop i had installed aironet client utility(ACU) also but during installation i did not choosed LEAP(because there is no radius server).On aironet 1200 ethernet port i can connect from my same laptop and can do configuration through web interface and telnet .
IP = 10.0.0.1 / 24
GW = 255.255.255.255 (which are by default on aironet 1200) . On my laptop's AIR-PCM352 card i had configured 10.0.0.3/24 , but it is not coming up . I had used different IP ranges and had tested with other aironet 1200 also but all in vain .
I had checked the status & activity LEDs of the PC wireless card and lights are coming on that so this means that nothing to do with the card . And in Aironet Client Utility(ACU) i can see signal qulity 0% .The antenna on aironet 1200's 2.4 GHz port is indoor antenna with 60 degrees E-Plane & H-Plane . I had put the antenna on 2nd port also but still the signal quality is 0 % . What could be the possible problem .
SSID is also correct

BasicITOne

2002-08-27, 9:28 am

The link and status light I have found to be very unreliable. If you are not getting any signal at the the laptop then the laptop will never connect now matter what IP you put. Check the card in another laptop or another card in same laptop. Turn off all WEP and security features (I assume this not production)then try to connect.

haseeb_eng

2002-08-28, 2:22 am

I had tried all these tricks

the OS version was 11.42T . And i had upgraded it to 11.50 , still same situtation . But after the upgrade in the radio led a continues red light was coming and in the express setup Role in Radio Network was gone

. And after that i was searching for Radio Firmware file but could'nt find it out in the net

. So now i had put back that image again and thinking to open a TAC case .

Sponsored Links