| devecchio 2002-04-13, 9:03 am |
| please, please help. I am confident the gurus here will provide an answer.
Can anyone tell me how to set up a cisco ubr904 cable modem/router to get over the cable company's evil plan to use dhcp(not supported by nat) to allow more than one pc to access the internet. I have tried nat, but it didn't work. I do not have a public ip address for the modem is behind the cable company's network. Here is my startup-config......by the way....I could not enable routing because when i reboot it can't find the carrier.
!
! Last configuration change at 20:02:20 - Fri Apr 12 2002
!
version 11.3
no service pad
service timestamps debug uptime
service timestamps log uptime
no service password-encryption
!
hostname Router
!
enable secret 5 $1$PxOU$jKkNy4.ph5A1SFjaXrEkO.
enable password password1
!
no ip routing
clock timezone - -8
!
!
!
interface Ethernet0
no ip address
no ip route-cache
bridge-group 59
bridge-group 59 spanning-disabled
!
interface cable-modem0
ip address 10.128.8.62 255.255.248.0
no ip route-cache
no keepalive
cable-modem downstream saved channel 585000000 51
bridge-group 59
bridge-group 59 spanning-disabled
!
ip default-gateway 10.128.8.1
ip classless
!
!
line con 0
line vty 0 4
password cisco
login
!
end |