|
Home > Archive > CCNP > February 2001 > Answers needed for BCMSN questions URGENTLY??
You are viewing an archived Text-only version of the thread.
To view this thread in it's original format and/or if you want to reply to
this thread please [click here]
| Author |
Answers needed for BCMSN questions URGENTLY??
|
|
| Nadia 2001-02-23, 12:18 pm |
| Can anybody answer the following questions please,
1) what is the autoargument on catalyst 1900 series? (choose two)
a)valid on 10 baset port
b)default for 100base tx port
c)negotiates full duplex
d)places 100 base tx into full duplex-flow-control
2) What is the functional ethernet connection between user and access layer switch?
a)ip address
b)enable access
c)interface ethernet
d)config ethernet
3) to enable fast etherchannel enter:
a)set link ch
b)set port ch
c)set ch fast
d)set ether ch
4) By default logging is send to the console. Which command u use to see logging send to other palce other than console (not sure the way i presented the question is right)
5) which command do you use to improve spanning-tree convergence?
a)set spantree portfast
b)set spantree priority
c)set spantree backbonefast
d)set spantree uplinkfast enable
6) Which statement about the Cisco Group Management Protocol is true?
A. CGMPv1 does not support leave messages.
B. When a CGMP- enabled switch receives a Leave Message, the switch starts a query-response timer.
C. If a CGMP enabled switch no longer supports any group members on a given port, that switch must issue a Leave Message to the router for that group.
D. CGMP enabled switches use randomly set delay timers when responding to CGMP Membership Report queries to avoid broadcast storms.
E. Switches supporting CGMPv1 and CGMPv2 can coexist in the same multicast group; however, all CGMPv2 messages are disregarded by the switches supporting CGMPv1.
7) What is the purpose of VTP?
a) to propagate global VLAN information
b) to set trunk priority levels for adjacent switches
c) to make sure that there is a trunk or VLAN1 operating
d) to map the non-contiguous switch fabric across the global VLAN.
Thank You | |
|
| ok let me help you out with some but please dont rely on the answers cause i may have them wrong...
1)c & d
2)b
3)b
4)show logging
5)c
6)i think b but like c not sure
7)b
hope I helped | |
|
| hey nadia,
email me......
regards,
helen..... | |
|
| hey helan I am still waiting for your reply... whats up? |
|
|
|
|