|
|
Identify the statement which connects access-list 101 inbound to interface e0?
A.) Router(config-if)# ip access-group 101 in
B.) Router(config-if)# ip access-group 101
C.) Router(config)# ip access-group 101 e0 in
D.) Router(config)# ip access-group 101 e0 in
answer: A sure
Identify the command that displays the SAP table?
A.) show ipx servers
B.) display SAP table
C.) display SAP's
D.) show sap table
answer: A sure
Identify the command mode necessary to enter the extended ping command?
A.) Router#
B.) Router>
C.) Router(config)#
D.) Router(ext-ping)#
answer: A not sure
Identify the command that specifies Serial 0 in slot 1?
A.) Router(config)# interface serial1/1
B.) Router(config)# interface serial1/0
C.) Router(config)# interface serial0.1
D.) Router(config)# interface serial0/1
answer: B sure
Identify the command to configure the configuration-register?
A.) Router# config-register 0x2102
B.) Router(config)# config-register 0x2102
C.) Router(config-reg)# 0x2102
D.) Router> config-register 0x2102
answer: B sure
Identify the command that will display the RIP routes entering and leaving the router?
A.) Router(config)# debug ip rip
B.) Route# debug ip rip
C.) Router>debug ip rip
D.) Router# debug rip routes
anser B sure
'Show cdp neighbors detail' show the following 3 pieces of information?
A.) Hardware platform
B.) Software version
C.) Same as 'show version' command
D.) Up to 1 address for each protocol
E.) Non-direct connected routers
answer: A,B of coure, but C not sure
Identify the command to run 'setup'?
A.) Router(config)#setup B.) Router?setup
C.) Router#setup D.) Router>setup
answer C not sure |
|